HP DRAFTMASTER DRIVER DOWNLOAD

9. Juni 2019 at 23:37

This page requires Javascript. This code refers to slow scan. Focus on what is used today. Take care to accurately align the left pinch wheel with the left edge of the media. The plotter fails to move the media back and forth to check its size and alignment when the lever and cover are lowered. Turn the plotter off and then on again to clear the display. Modify your browser’s settings to allow Javascript to execute.

Uploader: Kijinn
Date Added: 20 May 2017
File Size: 44.22 Mb
Operating Systems: Windows NT/2000/XP/2003/2003/7/8/10 MacOS 10/X
Downloads: 11100
Price: Free* [*Free Regsitration Required]

If the plotter needs service Locate the nearest service authorized HP Dealer in the local area. The message Calibrating will display.

HP DraftMaster MX and MX Plus Plotters – A Quick Reference Guide | HP® Customer Support

The display on the front panel may also indicate an X- or Y-Axis failure. Run away while you can. When this process is complete, the plotter will display Cut page, rotate 90 degrees. Position Overflow, indicates that an overflow occurred after an internal calculation was performed. Align the white arrow on top of the left pinch wheel with the left side of the media. Make sure the pen is operational. The cut edge of the media should be along the left side of the plotter. The plotter is calibrated at the factory using E-size AO polyester film and a black drafting pen.

Javascript is disabled in this browser.

These four codes indicate the left edge was found in a non-grit wheel area. Flaming or offending other users Illegal activities: Advertisements or commercial links.

HP DraftMaster I, II, SX, RX and MX Plotters – Plotter Calibration

See your browser’s documentation for specific instructions. If the above does not solve the problem, the plotter will have to serviced.

Set the port parameters to match the plotter settings that is, baud, 8 data bits, 1 stop bit, and hardware flow control. This one tip will help you sleep better tonight A few seconds draffmaster all you need to get a better night’s rest. Handle the film by the edges so as not to get fingerprints on it. Load a sheet of E or D size polyester film in the plotter. Make draftmastsr that the plotter’s serial port settings are set to the factory defaults.

How does HP install software and gather data? Check software documentation for appropriate serial settings if draftmasrer. Europe, Middle East, Africa. Five conditions exist that may cause a “Check Pen and Paper” error to occur:. If the calibration fails, the message Calibration failed will display. This page requires Javascript. Main cause is stiction in the Z-Axis. Turn the plotter off and then on again before plotting.

Fix by replacing the pen carriage assemble. Back to Speakeasy forum 5 total posts. Ordering manuals for a plotter. HP recommends an authorized HP service technician perform the calibration.

HP Computer Museum

This error condition will not interfere with plotter operations. This was helpful 0. Since, your product seems to be older, look at legacy side of support.

Three conditions exist that may cause a Y-Axis Failure to occur:.

The post HP DRAFTMASTER DRIVER DOWNLOAD appeared first on Sevac.